AUWiring

Lighting and estimating tables

Lighting load, cable estimating, cable tray, reel, waste-factor and IP rating tables.

  • 5 tables
  • Australia

Lighting and estimating tables project basis

Lighting load, cable estimating, cable tray, reel, waste-factor and IP rating tables. These tables identify units, field names and source values before a calculator run or worksheet review.

More

Confirm the nominal 230/400 V a.c. or project-specific voltage basis, 50 Hz context where applicable, phase arrangement, metric units, manufacturer information, DNSP or authority conditions and current project documents before applying a result.

Use table values only with the current project documents, product data and applicable Australian requirements that control the final decision.

Records covered

  • Lighting load fieldsLighting circuit load record fields for Australian lighting worksheets and switchboard load schedules.field-table · 2026-07-13
  • Cable estimating fieldsCable estimating record fields for Australian cable quantity and cost worksheets.field-table · 2026-07-13
  • Cable reel and waste factorsRecord fields for cable reel, allowance and waste-factor worksheets in Australian electrical estimating.field-table · 2026-07-13
  • Tray and conduit worksheetCable tray, conduit and containment quantity fields for Australian electrical estimating records.field-table · 2026-07-13
  • IP ratingsIngress protection rating digit meanings for Australian electrical equipment selection records.data-table · 2026-07-13

Review before applying

Lighting and estimating tables support calculator inputs and worksheet context. Keep each lookup beside the current project documents, Australian requirements and the calculator page that owns the final entered result.

Recheck the selected table whenever the supply arrangement, equipment data, route length, tariff basis, measurement method or project document set changes.